802.22,
In an effort to help get feedback on your response to you sooner than
later, we offer the following rebuttal.
1. Comment on Following instructions:
From the PAR instructions: Please enter the amendment title in the text
box. The title should be sufficiently unambiguous, understandable by a
NesCom member not from the society that submitted the PAR. All acronyms
shall be spelled out in the title.
We would encourage you to change the title, Scope and Purpose to meet the
requirement.
2. In the Distict Identity, the instructions has "two Shall" statements,
so we do not believe you can simply say "it does not apply". Your Title,
Scope, Purpose are REQUIRED to be easy for the document ready to determine
what is in the document.
IE: from the 5C
Distinct Identity
Each IEEE 802 standard shall have a distinct identity. To achieve this,
each authorized project shall be:<?xml:namespace prefix = o ns =
"urn:schemas-microsoft-com:office:office" />
a) Substantially different from other IEEE 802 standards.
b) One unique solution per problem (not two solutions to a problem).
c) Easy for the document reader to select the relevant specification.
Note From the NesCom conventions:
4. Clarity in PAR Content and Title
NesCom shall only approve PARs where the title, scope and purpose are
sufficiently unambiguous, as to be understandable by a NesCom member not
from the society that submitted the PAR. All acronyms shall be spelled out
at first use.
5. Scope and Purpose of the PAR
The scope and purpose of the PAR shall be written in complete sentences
and with proper grammar. The scope and purpose should be distinct and
separate statements. References to other standards within the scope and
purpose shall include the number, title, date (if appropriate), and source
of the referenced standards. For PARs approved after 01 January 2007 for
new or revised standards, the scope and purpose (if applicable) must match
the scope and purpose clauses of the draft document submitted to RevCom. A
purpose clause is not mandatory. If the document will not contain a
purpose clause, this should be noted on the PAR form.
So we would encourage 802.22 to change the Scope and Purpose to be in
"present" tense etc as per the rules/requirements.,
Generally the Scope tells "what", the purpose tells "why" as per the document.
The need section speaks to the project.
Regards,
802.11 PAR review Adhoc
----- Original Message -----
From: "Gerald Chouinard"
<<mailto:gerald.chouinard@CRC.CA>gerald.chouinard@CRC.CA>
To: <<mailto:STDS-802-SEC@LISTSERV.IEEE.ORG>STDS-802-SEC@LISTSERV.IEEE.ORG>
Sent: Wednesday, July 20, 2011 5:02 PM
Subject: [802SEC] 802.22a PAR comment responses
> All,
>
> 802.22 received comments from 802.11 and 802.19 on the proposed 802.22a
PAR
> and 5C for amending the main 802.22 Standard with MIB and management and
> control interface. The comments and responses have been aggregated in:
>
>
<https://mentor.ieee.org/802.22/dcn/11/22-11-0085-02-0000-802-22-response-on-comments-on-par-802-22a.ppt>https://mentor.ieee.org/802.22/dcn/11/22-11-0085-02-0000-802-22-response-on-comments-on-par-802-22a.ppt
>
> The resulting revised PAR and 5C can be found at:
>
>
<https://mentor.ieee.org/802.22/dcn/11/22-11-0059-11-0000-amendment-par-for-mibs-and-management-plane-procedures.doc>https://mentor.ieee.org/802.22/dcn/11/22-11-0059-11-0000-amendment-par-for-mibs-and-management-plane-procedures.doc
>
> For convenience, copies of the redline and cleaned versions in .doc and
> .pdf have been attached.
>
> Regards,
>
> Gerald
> 802.22 Vice-chair
>
>
> ----------
> This email is sent from the 802 Executive Committee email
reflector. This list is maintained by Listserv.
>
----------
>
> ----------
> This email is sent from the 802 Executive Committee email
reflector. This list is maintained by Listserv.
>