Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: [802SEC] Draft 802.15.4d PAR for 802 EC consideration in November



Bob:

When I last used the form, the autofill up to and including "Amendment:"
cannot be modified and is solely based on your selection of the document
to be amended.  You entered the amendment name in a box following the
autofill.

--Bob 

-----Original Message-----
From: ***** IEEE 802 Executive Committee List *****
[mailto:STDS-802-SEC@ieee.org] On Behalf Of Bob Heile
Sent: Monday, October 09, 2006 3:56 PM
To: STDS-802-SEC@listserv.ieee.org
Subject: Re: [802SEC] Draft 802.15.4d PAR for 802 EC consideration in
November

Bob

Thanks for your comments.  responses below.

Bob

At 12:49 PM 10/9/2006 -0700, Grow, Bob wrote:
>Bob:
>
>General -- Not sure why the Old Scope and Old Purpose fields are on the
>form.  I thought those were only supposed to be on the revision and
>modification PARs.  It appears you used the on-line form and selected
>amendment, so I further would assume the IEEE-SA programmers have
>introduced a "feature" or gone to a more generalized preview format.

I just followed what came up on the screen.  I have long since given up 
trying to understand the 'logic' of some of this stuff.


>2.1 -- You failed to provide an amendment title.

Did not spot that little "Amendment:" lurking at the end of the title
when 
it autofilled.  I will try it again.


>3.1 -- Fill in the Vice Chair information with no obvious reason for
why
>it isn't filled in.

oversite


>6.1.c -- Information is insufficient.  If the addresses are reserved
MAC
>or multicast addresses, then more information is needed.  If though
this
>is only an indication that an implementer will need a MAC address, then
>it shouldn't be filled in as this is the trigger for RAC coordination
>during Sponsor ballot.

It was not clear what was intended. Thanks for clarifying.  I will
revise 
the answer to no.


>Comments on 5C may follow.
>
>--Bob
>
>
>
>-----Original Message-----
>From: ***** IEEE 802 Executive Committee List *****
>[mailto:STDS-802-SEC@ieee.org] On Behalf Of Bob Heile
>Sent: Friday, October 06, 2006 5:00 AM
>To: STDS-802-SEC@listserv.ieee.org
>Subject: [802SEC] Draft 802.15.4d PAR for 802 EC consideration in
>November
>
>Dear 802 EC Colleagues:
>
>The following PAR and 5C were approved at the 802.15 Interim in
>September
>and are submitted for EC review in November.  The PAR address an
>amendment
>to 15.4 to add support for the 950 MHz band in Japan.  802.15.4
>currently
>supports the global 2.4 GHz band and regionally supports the 915 MHz
>band
>in the USA and the 868 MHz band in the EU.  Since there is no global
sub
>
>1GHz band, the goal is to add regional support for sub 1Ghz bands as
>they
>become available.
>
><http://ieee802.org/15/pending.html>http://ieee802.org/15/pending.html
>
>Regards,
>
>Bob
>
>
>
>Bob Heile, Ph.D
>Chairman, ZigBee Alliance
>Chair, IEEE 802.15 Working Group on Wireless Personal Area Networks
>11 Louis Road
>Attleboro, MA  02703   USA
>Mobile: +1-781-929-4832
>email:   bheile@ieee.org
>
>----------
>This email is sent from the 802 Executive Committee email reflector.
>This list is maintained by Listserv.
>
>----------
>This email is sent from the 802 Executive Committee email reflector.
This 
>list is maintained by Listserv.



Bob Heile, Ph.D
Chairman, ZigBee Alliance
Chair, IEEE 802.15 Working Group on Wireless Personal Area Networks
11 Louis Road
Attleboro, MA  02703   USA
Mobile: +1-781-929-4832
email:   bheile@ieee.org

----------
This email is sent from the 802 Executive Committee email reflector.
This list is maintained by Listserv.

----------
This email is sent from the 802 Executive Committee email reflector.  This list is maintained by Listserv.