RE: [802SEC] ISO versions of 802 standards
Tony-
At 04:31 PM 7/28/2003 +0100, Tony Jeffree wrote:
At 03:57 28/07/2003 -0400, Hayes, Vic (Vic)
wrote:
Tony and All,
A number of comments on your e-mail (I was not at the SEC meeting, so I
may
be out-of-order)
In my time it was important for 802.11's success to be recognized as an
ISO
standard (e.g. it was important in some countries to be able to refer to
an
ISO standard in order to adopt a local standard). The WG needed to
be
diligent in synchronizing their work with the ISO rules.
Nowadays, I agree that IEEE 802.11 standards are sufficiently accepted to
be
recognized without an ISO stamp.
You state that it would be confusing to have to versions of the standard.
In
fact there would be only one version that bears 2 designations. Only in
some
small areas where we could not agree on a clause, would we add a remark
that
the clause would only be valid for either the IEEE standard or the
International standard.
Vic -
One of the things that prompted me to make these comments is that 802.11
are currently proposing to fast-track *some* (not all) of the currently
approved 802.11 standard. This will definitely result in two versions of
the standard - the IEEE version will have 2 (?) amendments that are not
present in the ISO version.
I agree that not putting the full standard in for ISO is a BAD
IDEA!!
The situation will be exacerbated when the next revision to 802.11
integrates the supplements.
If an 802 Working Group is going to do this, then it should be all or
nothing as least per standard and preferably (strongly) per working
group.
However, the most
important item is the willingness of a person to be the
ISO editor, his preparedness to travel to the ISO meetings and to
strictly
coordinate with the IEEE staff to indeed obtain a new
version.
Absolutely. This comes under my comments about complications and extra
work.
Regards,
Tony
Geoff
Regards
---------------
Vic Hayes
Agere Systems Nederland B.V., formerly Lucent Technologies
Zadelstede 1-10
3431 JZ Nieuwegein, the Netherlands
Phone: +31 30 609 7528 (Time Zone UTC + 1, + 2 during daylight saving
time)
FAX: +31 30 609 7556
e-mail: vichayes@agere.com
-----Original Message-----
From: Tony Jeffree
[mailto:tony@jeffree.co.uk]
Sent: Saturday, July 26, 2003 12:20 AM
To: stds-802-sec@ieee.org
Subject: [802SEC] ISO versions of 802 standards
Having just taken part in the discussion in the closing SEC meeting
regarding submission of 802.11 standards to ISO, I am minded to make
a
motion at the November Plenary session to make it 802 policy not to
submit
802 standards to ISO in the future. There are a number of reasons, most
of
them rehearsed in this afternoon's discussion, why I believe that
having
ISO versions is a bad idea, including:
- Having two versions of the same standard leads to considerable
confusion
in the marketplace;
- IEEE already has a significant profile as an organization that
produces
standards (under their own brand) that are Internationally recognized,
so
the process is of marginal utility and simply serves to dilute the
IEEE
brand;
- Keeping the documents "in sync" is problematic at best, and
arguably
impossible;
- The process generates complications and extra work for the Editors
and
the IEEE staff;
- The relevance of ISO as a source of networking standards is
highly
questionable;
- As both ISO and IEEE will end up selling the document, there is
the
potential for loss of IEEE revenue.
I think it is time that we reviewed our position on this issue. I will
make
a motion at the Friday SEC meeting in November, and will remind you of
my
intent to do this at the Monday SEC so that there will be an
opportunity
for feedback on this from the WGs.
Regards,
Tony
Regards,
Tony