Thread Links Date Links
Thread Prev Thread Next Thread Index Date Prev Date Next Date Index

Re: Metric




Jim -

I see that your note does not cover the metric-ization of time. I
understand thet the metric replacement for the second is the
micro-fortnight - is this correct?  ;-)

Regards,
Tony

At 17:12 22/10/99 -0500, Jim Carlo wrote:
>
>Note policy below:
>
>     METRIC POLICY: After 1 Jan 2000, proposed new standards and revised
>standards submitted for approval will use metric units exclusively in the
>normative portions of the standard. Authoritative and detailed guidance for
>use of the metric system is found in IEEE/ASTM Standard SI 10.
>     There are three exceptions allowed in the policy statement: (1)
>products that are specified in non-metric trade sizes, such as the AWG wire
>series or inch-based fasteners; (2) cases, such as plugs and sockets, where
>a mechanical fit to an inch-based product is required; and (3) metric
>products need not be substituted for inch-based products.
>     According to Bruce Barrow, Chair of the IEEE Standards Coordinating
>Committee 14 (Quantities, Units, and Letter Symbols), this stage will
>transition as easily as Stage I (include metric units in standards) and
>Stage II (metric units given preferred status).
>     For assistance, contact Barrow at "MailTo:b.barrow@ieee.org".
>
>Jim Carlo(jcarlo@ti.com) Cellular:1-214-693-1776 Voice&Fax:1-214-853-5274
>TI Fellow, Networking Standards at Texas Instruments
>Chair, ISO/IEC JTC1/SC6 Telecom and Info Exchange Between Systems
>Chair, IEEE802 LAN/MAN Standards Committee 
>